Project Description

It is often interesting to check the degree of resistance of materials to liquids such as water, oil or other substances, tempering at a certain temperature according to the type of test. Such tests are usually performed in the thermostatic baths.

Features:

 

Immersion bath with water circulation
·         Volumes: From 27 liters to 5.000 liters
·         Temperature range: From room to +50 ºC.
  From room to +65 ºC.
  From room to +85 ºC.
  From room to +90 ºC (boiling).
  From +5 ºC to +50 ºC.
  From +5 ºC to +80 ºC.
Immersion bath with glycol water or glycol  
·         Volumes: From 27 liters to 5.000 liters
·         Temperature range: From room to +110 ºC.
  From 0 ºC to +110 ºC.
  From -20 ºC to 110 ºC.
Immersion bath with 2, 4, 6 OR 8 compartments
·         Volumes: Under demand
  Independent Feed circuit for each compartment.


Standard:

– Exterior: Lacquered sheet steel.
– Interior: Stainless steel AISI 304.
– Flat gate, for baths of +50ºC.
– For baths of more than 60 ºC, gate with angle, with chimney for steam extraction
– Four casters or adjustable legs (depending of models)
– Heating system by means of immersion armored heating resistances, protected by a grid. Heating power electronic control by statics relay (triacs)
– Circulation pump.
– Water inlet electronic level
– Closed water circuit / anticorrosive glycol
– Drainage key.
– Cooling system: cooling coil and independent cooling group installed outside.
– Temperature control with automatic adjustment and precise control system of the PID parameters.
– Probe: PT-100 Ohm, DIN Class A.
Optional:
– Programmer with communication port RS-232 and remote control software.
– I/O digital or analog for events.
– Liquid pressure manometers
– Analog flow meter.